Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

billcainautodesk
en respuesta a: robertbZJLLC

Hello robertbZJLLC

Most simulation errors in PartMaker have to do with the Tool Description creating a bad tool. This may happen immediately or like in your case happen while simulation runs. For instance one of the more common mistakes is on a Turn tool is to set the Width and Shank size the same value. This causes the Shank to end up in front of the cutting insert and can cause simulation to crash.



Bill Cain
Sr. Technical Consultant