- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Hello,
I would like to know how to make an inclined hole, attached drawing, thank you very much.
Hug.
¡Resuelto! Ir a solución.
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
In my shop with my available equipment I would do this part in a 4th axis machine. I could complete 80-90% of this part in one operation.
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Thank you very much for your answer, but it would be in the machining center 3 axes, I did it in this way attached, I hope it is correct.
thank you very much.
Hug
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
@Anonymous
That's exactly how I would do it. Create a new setup for each angled location. Obviously, if this is going to be set up on a 3 axis machine, you will need a fixture of some type to reach these holes.
Nice work!
Technical Specialist - CAM
SolidCAD - Canada

- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
Hello,
Thank you very much for your considerations, this was a great learning experience.
Hug.