Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

kelbie.ockey
en respuesta a: martin.reboux

Hey @martin.reboux! Just as a heads-up, this is the FeatureCAM Forum. You might get better help at the Fusion 360 forums.

 

That being said, here's a super-basic jumping off point for learning about these types of toolpaths in Fusion. Additionally, here is a link to our post library. Check here to see if a post already exists for your machine, as you will ultimately need one to generate your NC code specific to your machine. It looks like there are a couple Stepcraft ones that may work for you.

 

LMK if you have any other questions!



Kelbie Ockey
Sr. Implementation Consultant