Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Craig.Burney_DSI
en respuesta a: bhorstTGM48

@bhorstTGM48   Bill,  I do know the Fusion post library is getting worked on daily.  There are a lot of posts now available to Fusion users.  Also customizing them to your liking as well, the same as for FeatureCAM posts.  As far as getting Fusion posts up to speed with your current FC posts, I'm sure that can happen without too much effort just by comparing both posts side by side and matching them up.  By no means am I a FC post expert but I know the posts library for Fusion is growing daily.  Any more questions I'm sure Autodesk would have more answers.  Hope this helps!

 

 

Craig Burney
Senior Application Engineer
Design & Software International