Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

rgollob
748 Vistas, 5 Respuestas

FeatureCam/PartMaker/PowerMill Help

Ok guys,

New to FeatureCama and PartMaker. We've used Inventor HSM for a number of years and primarily use Siemens NX.

That being said our Lathe Dept. has been doing all the programming in PartMaker for our turn, swiss and mill-turn equipment. Sadly the sole programmer for that dept./software has passed away and I need to get my department trained up in this software(s). so I have a few questions:

 

1.What software is best to move forward in out of FeatureCam, PartMaker or Powermill?

 

2. I see all kinds of videos online showing the machine simulation in these software's, but I have yet to figure where to acquire the simulation files and how to get them setup. Where and how do I get them setup?

 

3. Are any of the files compatible with each other? (Open PartMaker Files in FeatureCam or Powermill)