Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

kgueorguiev
en respuesta a: gabriele.esposito

Gabriele, in the "Z Level Example" toolpath, did you draw a circle around each of the holes and select that as your boundary? I'm a little unclear about where exactly the boundary should be. At first I created two curves, one on the top edge and one on the lowest edge of the radius, and then offset those curves outward. Z-Level Surface Milling is what most people in our shop will be using, so I will focus on that before exploring other strategies.