Anonymous
261 Vistas, 1 Respuesta
11-24-2019
02:51 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
11-25-2019
05:51 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
11-25-2019
05:51 AM
Hi @Anonymous
not much information about this.
Assuming there are necessary System requirements for Autodesk FeatureCAM, it most likely depends on configuration files.
With a previous backup, remove the files from C:\ProgramData\FeatureCAM.
At the restart, these files will be recreated.
If this is not enough it is better to proceed with a correct installation.

Francesco C.
Application Engineer