Anonymous
en respuesta a:
Anonymous
11-19-2019
12:55 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
11-19-2019
12:55 PM
I started a new test program, created a I.D. groove, the end is wider that the opening, the tool has a bigger angle on it that the id groove but i cant seem to get the groove tool to follow the curve i created for the id groove, the tool just goes straight , any ideas on how the get the groove to to follow the gemoetry?