Anonymous
en respuesta a:
Anonymous
05-23-2019
12:13 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
05-23-2019
12:13 AM
I am assuming by "post file" they mean a post processor - the file that converts the FeatureCAM program into NC code that can be read by the machine tool.
Each post processor is specific to each machine tool as the code they need to perform certain actions varies from machine to machine. This is why they will need a new post processor if they have a new machine they'd like to create programs for.
I am assuming that you will need to contact Autodesk support for a new post processor and they will then give you a pin to enable you to download the relevant file? They can also make any machine specific customisations to the post processor for you if required.