03-21-2019
01:20 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
03-21-2019
01:20 PM
Have been trying to program this face groove using the face turn feature works up until the point of it plunging into the stock full depth around the curve then retracting back to carry on the roughing.......no idea why it would want to do this, any ideas?
Have also tried as a groove from curve but it doesn't like that either
¡Resuelto! Ir a solución.
03-25-2019
10:34 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
03-25-2019
10:34 AM
Found out that if you tick the skip wall pass on the turning properties page than it will not plunge through the component, no idea as to why it want to do the wall pass when in the middle of a roughing cycle