Anonymous
en respuesta a:
Anonymous
11-19-2018
08:16 AM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
11-19-2018
08:16 AM
Yes, I must agree. I can drill mill a half inch hole on my new Datron in half the time if I program them at the machine vs. using FC. when you have a machine that will run at 60,000 RPM. you can take that hole out with one or two passes without the tool ever leaving the material. The biggest problem all the way around with FeatureCam is cutting too much air. This adds a huge amount of time to parts and time is money.