Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Anonymous
en respuesta a: Anonymous

Yes I use that all the time when I am drilling with a drill, but that option is not there for the mill drilling option.

   I use rough with end mill to full size and all I get is a milling tab. The only option in this tab is the "z" step. I have tried using this, but it just makes it take it in more than one step. So what it appears that I have to do is calculate (or figure out) just how much extra each size drill would go down and subtract that off of the depth. unfortunately the depths don't seem to calculate out exactly as to how far FeatureCam is actually going. so I still have to make the hole see how much too deep it's going by looking at the post and then changing it in the feature.