Anonymous
506 Vistas, 2 Respuestas
08-15-2018
01:53 PM
- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
08-15-2018
01:53 PM
I have a question about projecting curves. I attached a picture of what I am talking about in this question. I would like to know if you can take a curve and slice it through a model so I can make a roll dimension. As you will see on the picture that I attached you will see a line above the part. I took that line and projected a line through the part. Can Featurecam do this? This was done in mastercam.
¡Resuelto! Ir a solución.