- Marcar como nuevo
- Favorito
- Suscribir
- Silenciar
- Suscribirse a un feed RSS
- Resaltar
- Imprimir
- Denunciar
I have been using Inventor and Fusion360 for a few months and have recently started educating myself on FeatureCAM as it is a need where I work. My question is about the differences between these three products. As I mentioned I have been drawing in Inventor, importing it to Fusion360 to develop tool paths. Since this new unit is only using FeatureCAM I cannot find the benefit of it. Does Inventor and Fusion360 lack something that FeatureCAM provides because from what I have experienced in the few short hours exploring it it seems like the shortcomings rests with FeatureCAM.
What am I missing?
Where can I begin?
Can I use the models I have made in Inventor in FeatureCAM?
Thank you for any information. I appreciate it.
¡Resuelto! Ir a solución.