Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

abhishek.juvekar
en respuesta a: benchou0223

Hello Emon and Ben,

 

It is not possible to change the export options back to 2012. However I verified it in Solidworks and there also the dxf exported from FeatureCAM imported properly without any problem with arcs. I am not sure in which software, these arcs are appearing incorrectly whereas Solidworks which is also an external software shows them correctly. Refer attached image from Solidworks and let me know if I am missing something.

 

Thank You.



Abhishek