Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

cfarber
1342 Vistas, 17 Respuestas

dead air cutting

Has there been improvements on FCAM see dead air space and creating toolpaths to not cut dead air on regions that have already been cut?

 

I have a .75" deep groove with .045" thick walls left with a 3d contour on top that makes the wall 0.75" high at the highest and .25" tall at the lowest in plastic so side wall flex is high therefore I have to make .25" deep steps down to depth. half of the groove cuts air from the material that was removed from the prior surface mill operation. Any ideas how can I stop the wasted dead air cutting?