Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

acad-caveman
en respuesta a: Anonymous

Hmm

 

 

  Just did it on an 8 sided part to make sure I didn't miss anything ....

Well, I didn't.

The Z-rapid plane is calculated from the extent of the stock, while the retract plane is calculated from the feature.

 

So the only thing I can think of is your post might not output a Retract to Z-rapid plane before indexing.

 

Just for giggles, in your operation settings -> Misc, check if the "Retract to plunge clearance" is ticked in.

If it is, then quite possibly that is your problem as the tool does not retract to the rapid plane between ops.