Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Anonymous
en respuesta a: acad-caveman

Hi

 

I tried this. The UCS moves just fine I selected the option to leave the tool paths in place relative to the stock. 

 

When I run a simulation, it pretty much has a meltdown. the tool paths gouge all over the place, this looks like it doesn't factor for the new retract height but even when I increase the retract to allow for this, it still starts cutting the stock it finds at the new Z position rather than leaving the toolpath in place.

 

It looks like the Z retract has to be set to double the change in UCS height to clear the part.

 

This is what it should look like for one op,

followed by what happens after moving the UCS,

followed by the same but correcting the gouge from positioning by making a massive adjustment to the retract height.

 

Using Featurecam 2017 on Windows 10 if that helps

 

Does anybody know what I'm doing wrong?

 

Thanks

 

Paul

 

 

 

1st op.JPGMoved UCS.JPGRetract changed.JPG