Anuncios

The Autodesk Community Forums has a new look. Read more about what's changed on the Community Announcements board.

Anonymous
en respuesta a: abhishek.juvekar

no, I should have been more clear in my initial post.

 

we use this operation on a two axis lathe, we drill the hole with an inserted drill then proceed to use the drill as a de facto boring bar to get us out to a rough dimension. I have been hand writing this portion of the program but was curious as to whether featurecam had a feature I could use for this operation or if it would require some sort of work around. hand writing it is not the end of the world, however I was just curious if this was something built into the program or not.