01-06-2021
03:57 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
01-06-2021
03:57 PM
Thank you again @daniel_lyall . I do have a smaller bit (1/32"). The boundaries of this model are intended to go slightly outside of physical stock dimensions for the purpose of miniscule slop in my precut blanks and holding jig. With 6 sides per cube and producing many of these, I was hoping to find a sweet spot between speed, finish, and no tool changes if possible. That is the obvious Holy Grail of anyone though. I will continue to tweak and test.
Fusion