Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
JOKM_Creative
in reply to: seth.madore

Thanks @seth.madore ! That's sort of what I thought. The cabinet software I use - Mozaik - does this when there are tabs and I was hoping to do something similar. 

 

I ended up running a .125" tool around the perimeter of the parts today and they stayed put. Because the cutting edge is only .5" and the material is 0.625", I was thinking the shank of the tool might just bump the edge of the part before it damaged it. This happened with one cut-off scrap with no catastrophic effects!

 

Thanks for moving the post. I did try and find the MFG forum, but I think I was looking for 'CAM' and just glossed right over 'Manufacture'!