12-04-2020
09:30 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
12-04-2020
09:30 AM
Yes, it is possible to use main model, I encountered some issues when attempting to drive tool past edges and fiddling with options did not please my fancy so I made offset of groove surface without adding any value to it.
I then extended edges past main model, constructed sketch and extrude it to cut off round side of new surface.
I then selected that surface as model in setup to get strait passes overlapping main model edges without tool path spilling over into goofy motions.
Fusion