Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
nicktoepfer
in reply to: daniel_lyall

I have tried to re start the computer.  I have found that 90% of the time that corrects many issues...  it was not helpful in this one however. 

 

I am using a machine produced by Bulkman3D so not exactly a high dollar machine, I use MACH 3, so I chose the Artsoft post process.  Am I making a mistake here?  Did something change in the last few weeks that I should have known about?  

 

I have tried making new setups and ensuring that they are defined with a ucs.  the tool paths show correctly on the simulation and but fails when its time to post.  Like I say it will produce code if I open the TAP file after I close the warning window, but I don't trust it.