10-28-2020
05:25 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
10-28-2020
05:25 AM
Ran into this as well. Normally running one-off prototype parts so never paid much attention. But recently got a pretty big order of a bunch of parts. According to Fusion, one of the setups was supposed to take 94 minutes, the actual machine time was 127 minutes. This is just one setup of 4 for one of 36 parts we have to make.
I used the Fusion numbers to roughly calculate how many of these we can make a week, obviously was quite a bit off. Seems very strange it's that far off. Using a brand new Haas, full rapid, so not sure how Fusion could be off so much.
Fusion