04-25-2020
01:35 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
04-25-2020
01:35 PM
I thought about this, but i was hoping someone who has experience with doing that could confirm that I don’t need to change my WCS zeroes. If I’m probing a corner of my stock, do I need to probe a different corner? I ask because when I select “do not keep original”, it shows the mirrored toolpaths outside of my setup stock. I’m looking for a way to program a part, run that part with one program, and then run another part at a different time with the mirrored program. Any ideas?
Fusion