Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
j9lemmon
234 Views, 3 Replies

Unexpected movement during a 2D Contour

I created a 2D Contour to cut out a part. When ran a Simulation there was an expected movement at one outside corner; it looked like it was drilling a hole at the point. This was at the retract location. In the toolpath, there was a stack of green arrows at the point. Screenshot attached.
Green arrows at the point where bit does a circular movement each time it passes this cornerGreen arrows at the point where bit does a circular movement each time it passes this corner