Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Richard.. thanks so much!

 

Instead of using the sketch method I just picked a point and used the toolpath front and back geometry with offsets to position the beginning and end of the toolpath. Seems to work well.

 

There is 1 little quirk though.. I'm getting a Feed command at the beginning of the second knurl toolpath that I don't think I'm defining anywhere.

 

it doesn't matter which order I put them in it shows up when I have both toolpaths back-to-back.

 

N196 G1 X2.3 Z0.1969 F0.66667

 

It's not a game breaker or anything, it just seems to come from out of nowhere.