03-25-2020
02:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
03-25-2020
02:47 AM
For the bump knurl I would use a single grooving pass and turn on the dwell before retract.
For the feed knurl I would then just use a traditional Finishing pass but make sure its starts on and off the job sufficiently, you may have the best results drawing a sketch line for this.
We haven't got a Knurling tool you can define in the library, I would define a grooving tool to show the same dimensions as your knurling tool.
Hope this helps.

Richard Stubley
Product Manager - Fusion Mechanical Design
Fusion