Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Anonymous
383 Views, 4 Replies

Toolpath issues

So, I have a design for a sign that's being done on a 8"x12" piece of 1/8" acrylic with 2" high lettering.

 

This is my first time trying to use Fusion for creating the toolpaths(I was using Easel before this), what I can't seem to figure out is how to crate a toolpath that will engrave properly.  I tried using the Engrace path at first, but the bit I'm using wouldn't allow it(1/32" upcut).

 

I attached a copy of the design and would appreciate any help.