01-19-2016
06:27 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
01-19-2016
06:27 PM
I will simply add that the default consideration in Fusion 360's CAM is that you select the model in the setup. This applies (3D) toolpaths in a model-aware fashion. I will say that until my current job (and we don't use Fusion) I was also used to the old way: mostly 2D paths programmed in whatever CAM package I had, previous jobs including Mastercam X6 and GibbsCAM 2012+ for which models were used sparsely if at all.
This is not that CAM. ![]()
Neal Stein
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
Fusion