01-19-2016
04:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
01-19-2016
04:50 PM
@Anonymous wrote:Chris,
I remodel your bottom jaw and I didn't have to select the model in the setup section. I still got the parallel toolpath to work. However, with your model you do have select it for the setup so the toolpath generates. Not sure what's causing the difference in your model vs. mine but I was able to get it working without using the model in the setup section.
I attached my model if you care to look it over.
Mark
I'm sorry, but this isn't making the feature he wants, and that can be seen in the Simulation:
Without selecting any sort of geometry the software is just making a sort of approximation based on your bounding area.
Neal Stein
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
Fusion