Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Anonymous
384 Views, 3 Replies

Turning-Gang Block

Useing Gang Block Tools--Is it possible to Cut on the Negative side of X (rear post)?

Where would you tell a Profile to do this ??

             Thank You   Rick

jeff.walters
in reply to: Anonymous

not yet but its being worked on

Jeff Walters
Senior Support Engineer, CAM
Anonymous
in reply to: jeff.walters

Thank you for your quick reply--

Will be looking forward to the improvement-

                        Rick

Any updates on this? I would love to be able to run both side cutting tools instead of all one.