08-06-2019
01:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
08-06-2019
01:51 AM
Hi @kim.salvesen,
I've been looking through the Heidenhain manuals and can't see that they provide support for what we refer to as probe geometry.
The cycles I can see are all for setting a WCS but not for doing a decision based on the size or position of a feature, or updating tool wear.
If you have cycles that allow you do do this then I would be interested in reading the revision of your manual.

Richard Stubley
Product Manager - Fusion Mechanical Design
Fusion