Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
cnctv
358 Views, 5 Replies

Need Help on CAM with this part

Ok this should be easy or so I thought but I tried several different approaches and all give me a bad toolpath. So can someone here maybe point me into a solution. I am not sure if this is any of the issue, but this part is one I imported and this piece is part of an assembly. So I just turned off the other part and selected this as the body I am machining. I would think this would be all i needed to do but if that's wrong then pleaseFusion 10.PNG let me know.

 

Thanks always for the help!