05-20-2019
06:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
05-20-2019
06:47 AM
I think there are a few out there, but it's honestly not something I've put any time into. I'm fairly certain it's not as simple as putting another piece of software on your CMM machine and getting it up and running on the new software. But, I could be way wrong on this...
Yes, it's just a bridge mill receiving feedback from the scales and the probe. I'd look at OpenDMIS for starters, if you are looking at going down this route. I suspect Autodesk isn't going to invest time into a "cobbled together" solution for this, but rather work closer with OEM's to provide a stable solution. But again, that's just suspicion.

Seth Madore
Customer Advocacy Manager - Manufacturing
Fusion