Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Xray965
in reply to: seth.madore

Your a life saver Seth, spent 3 days trying to hash this out on the post processor, completely forgot that the spring pass would output an additional line.

 

My flastcutcnc controller reads the G76 output as follows:

 
G76 X0.464 Z-11. K1 D0.01 F0.5  
G76 
X = Minor Diameter
Z = Length of Thread
K = Height of Thread from Minor diameter
D = Depth of cut for First pass
F = Screw pitch
 
The rest of the passes is controlled by the machine configuration under threading panel.
 
I spent the last 3 days on this trying to see where the problem was, till just drew a blank and asked for help on the forum, thank you., it's working perfectly now.