Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Hi @daniel_lyall  We discussed this a bit in another thread, the problem with G17 on a line on its own. I wonder does G17 need to be reset for anything other than arcs?

 

Throughout the post G17 is reset, here for example in onLinear.

 

Clipboard02.png

Is it worth using a search\replace and comment them out with 

//writeBlock(gPlaneModal.format(17));

All the arc moves will set the correct plane when needed so not sure if G17 is needed anywhere else. It might be needed for drill cycles, if so just add it to onCyclePoint.

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature