Anonymous
248 Views, 1 Reply
02-10-2019
02:36 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
02-10-2019
02:36 PM
Error: Internal CAM kernel error. Please report through your support channel.
this is a program that previously ran fine, i had to make a tiny change (g54 shift) which required me to regen all toolpaths, all but 2 regen'd fine except some chamfer paths. i tried rebooting the software, the computer. tried to make a new toolpath, they all give the same error. i'm dead in the water without this!
02-11-2019
06:37 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
02-11-2019
06:37 AM
Hello
It's hard to say anything about the problem without looking at your file. Are you able to share it with me, either here on the forum, or to me directly?
Regards,
Björn Johnsson
Sr. Software Engineer for HSM CAM

Bjoern Johnsson
Principal Software Engineer
Fusion