12-03-2018
02:53 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
12-03-2018
02:53 PM
Hi so let's get this right you have to do your work piece under the ten mm to a chart
On the threading insert page you have to put in 1.5 not 3 as the insert is
Then you have to put in 16 .5 for length as it says 16 mm on there web site for that insert
So if I was doing a m10*1 I would have to go to my insert page and change the pitch to 1 and get the major dia and miner dia devide by 2 thanks for all your help Steve
On the threading insert page you have to put in 1.5 not 3 as the insert is
Then you have to put in 16 .5 for length as it says 16 mm on there web site for that insert
So if I was doing a m10*1 I would have to go to my insert page and change the pitch to 1 and get the major dia and miner dia devide by 2 thanks for all your help Steve
Fusion