Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Marco.Takx
in reply to: sean

Hi @sean,

 

The warning you get is that the toolpath isn't milling this whole negative angle face because you limited on the Heights tab the Bottom Height to Model Bottom.

2018-11-30_12-29-20.jpg

Increase the Bottom Offset with a - value that is big enough to go down the part and mill this whole face.

Then the warning is also gone.

 

2018-11-30_12-31-33.jpg

 

If my post answers your question Please use  Mark Solutions!.Accept as Solution & Give Kudos!Kudos This helps everyone find answers more quickly!

 

Met vriendelijke groet | Kind regards | Mit freundlichem Gruß

Marco Takx
CAM Programmer & CAM Consultant