Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
sean
1781 Views, 2 Replies

Swarf toolpath tool lifted warning

I am trying to generate a swarf toolpath to clear and finish an angled face on my part.  The geometry is very simple, so I did not think I would have any issues with this approach.  However, every time I generate, Fusion is automatically lifting the bottom of my tool to about the middle of the face I am machining.  I have included an image of the incorrect toolpath and the warning message below.  I have tried adjusting all the parameters I can think to adjust, but nothing is getting rid of the automatic lift.  Images of all my parameters are also shown below.  I suspet it has something to do with linking, but am not positive.  If I cannot figure it out, I plan to tell my machine that the tool is shorter than it is so that it actually cuts down far enough, which obviously is sub-optimal.  Thanks for any advice anyone can give on this.

 

Geometry tabGeometry tabHeights tabHeights tabPasses tabPasses tabLinking tabLinking tabToolpath and warning messageToolpath and warning message