11-29-2018
07:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
11-29-2018
07:33 AM
I'm having similar issues with using an offset boring head in my mill. Looking through the Fusion options, it appears that the "Fine Boring - Shift" (under the drilling tab) would be the most suitable, but it doesn't recognise a boring bar. Note, for this operation, just like the original poster, I want the table to move so spindle centre is concentric with the hole centre, and then not move - only a Z move required.
Fusion