09-17-2018
03:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
09-17-2018
03:43 AM
The cost is quite low; right now, until Oct. 1st, you can purchase for $310/yr. After that it will be going up to $495 USD.
Now, will it do the job? Hard to say. It will do most of it right out of the gate. I know they just wrapped up a Mazak Integrex, all programmed by Fusion.
A post processor would need to be created or modified for you.
Multi-channel CAM is not quite possible in Fusion, although it's something they are working on. They will be porting in a fair amount of Swiss Lathe type stuff in the coming months/years.
Seth Madore
Owner, Liberty Machine, Inc.
Good. Fast. Cheap. Pick two.
Fusion