Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
sstephe1622
in reply to: Steinwerks

Do you know Fusion side if there is a way I can set a maximum feed value?  The problem I ran into is that once the feed goes over F10000+ the controller can not interpret the value and the program freezes at that point.  I went in and edited the code by hand for any value greater then F9000 but it would be nice to do it software side to help eliminate the hand editing.

 

Other thing I noticed if that for rapid moves it has a feed of F.8XX (Can't off hand remember the last two digits.) So it takes an eternity to go from one side of the part to the other side of the part.

 

Thanks