07-28-2018
07:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
07-28-2018
07:43 AM
Thanks for the reply. This however is not the case. Tool length compensation is being cleared between operations with the same tool and the subsequent operations with the same tool are being executed at Machine zero instead of tool zero. There’s no G49 in the code.
G28 automatically suspends the tool length compensation.
I can use G53 in most cases instead, but this is still a glitch with the post that should be corrected. Tool length compensation must be reinstated after a G28.
G28 automatically suspends the tool length compensation.
I can use G53 in most cases instead, but this is still a glitch with the post that should be corrected. Tool length compensation must be reinstated after a G28.
Fusion