Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
HughesTooling
in reply to: Anonymous

@Anonymous I noticed you selected a ripper for the adaptive cut, they can have what's equivalent to a small rad on the corner so that can be a problem. Is it a course or fine ripper, might be worth setting it up as a Bullnose and a 0.5 - 1.0mm corner rad but you'll need to be careful not to set it too big or it might remove too much material on the angled parts.

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature