Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
HughesTooling
in reply to: Anonymous

You are getting the collisions for 2 reasons. One you have not enabled stock so the op doesn't know it needs to pocket rather than clear leaving a boss.

 

The second reason has come up before but was not taken seriously in the replies and is caused by smoothing. It looks like all the leads are added before smoothing is applied so after smoothing the endpoints shift a bit and what where vertical leads end up angled. See attached file, I've enabled stock and disabled smoothing and there are no collisions, in the second op I enabled smoothing gererates collisions!

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature