- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Hello Amanda, Martin,
Cheers for the reply! For now the issue is resolved as the desktop at work did manage to complete the adaptive toolpath calculation after I restarted Fusion 360. After it was complete I have never tried to reproduce the issue though. It takes the hardware of the work desktop about 10-15 minutes to complete the toolpath calculation. I had to get back to the drawing table to adjust the design anyways so more fiddling with the adaptive toolpath will come later. If the issue pops up again I will report back here.
@AmandaFowler For the design it was important to be able to use the largest stepdown possible to reduce machining time. It was set to 30mm. The fine stepdown option was set to 5mm I think.
Thanks for your assistance, have a nice day!
Pascal
Fusion