Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Anonymous
1111 Views, 4 Replies

[Pending] Toolpath issue

Hello,

 

I am experiencing a ''pending toolpath" issue on a desktop at work. I am still able to use the desktop while the issue pops up in Fusion 360 (ultimate). All other applications run noticably slower while the toolpath remains on ''pending'' status. In my case it has been on "pending" status for over 15 minutes now and nothing happens. It won't generate the toolpath. It popped up after I interupted the initial generation of the toolpath. It was on about 51% completion when I remembered I had to change something. I went to edit it and after I changed something it got stuck on "pending". It's a quite large 3D adaptive clearing toolpath for a large design. The geometry itself is not too complex I would say.

 

For confidentiality reasons I can't add a public link to the design here in the forum thread. I can PM a public link to the design to a moderator or an autodesk employee.

 

System specs:

Windows 7 Professional 64-bit

12 GB RAM

Intel Xeon E5-1607 0 @ 3.00 GHz

AMD FirePro V4900 (FireGL V)

 

Thanks in advance,

 

Regards,

 

Pascal