02-02-2018
07:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
02-02-2018
07:07 AM
We were all new at some point, so no worries there.
Make sure to set up a machine profile (for each machine model) in HSMAdvisor, the default one for the Haas 12k direct drive spindle has been spot on, but I did set one up for our Fadal that works pretty well. This will help you fine tune actual load using the torque curve of your machine(s) and I have found it very useful.
Those charts are handy starting points but obviously conditions can vary drastically between machines. A Brother Speedio won't take the cut that an OKK can and the charts are rarely good for that sort of difference.
Neal Stein
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
Fusion